How to Change a Flat Tire After a Blowout

tire-flat-change.jpg
This weekend we traveled to the Nevada desert and were probably going a bit too fast on a dirt road. All it takes is a sharp rock and BOOM there goes your tire which is exactly what happened.

Fortunately, it was the rear tire and after the blowout, we came to a quick stop. That didn’t keep the rim from getting messed up as it was dented on a couple of edges.

We’ve got a full-size spare so after assessing the damage we went to work on changing the flat tire. We were in the middle of the desert so AAA was not a viable option.

Here are the basic steps to changing a flat tire. Instructions will vary based on the type of jack you have and where your spare is located.

Assess the Situation

After you’ve come to a safe stop make sure you are pulled off to the side of the road as far as you can and if you have them place orange safety triangles or cones behind you or raise your hood to signal to other motorists that you have broken down so they slow down.

Remove the Spare Tire and Jack

Spare tires are typically located in a well in the trunk beneath the carpet. The jack and tire iron will be there as well. In some vehicles, the spare tire is located in the rear storage area or under the vehicle or attached to the rear door. It’s best to periodically check your spare for air and any tire damage such as rot.

tire-blowout-desert.jpg

Remove the Flat Tire

I’ve found it’s best to loosen the lug nuts first before lifting the tire off the ground. You can pull with more force without worrying about the vehicle falling off the jack or the wheel moving.

Raise the Vehicle

After the nuts are loose then follow your vehicle manufacturers instructions and raise the car. Place chock blocks in front or back and put the emergency brake on before raising the car. Make sure the ground below the jack is solid and not at an angle.

Hydraulic lifts will require you engage the jack by turning a bottom switch to the right. Then when you pump the jack it will raise. When you are done you simply turn the switch to the left and it will release the jack and the car will lower.

Attach the Spare

If you have a full-size spare you are in better shape and will be able to maintain normal speeds but with a small spare you need to change it and get to a garage as soon as possible. Hand tighten the lug nuts but there is no need to overtighten.

flat-tire

Keep the Flat Tire

You’ll need to reuse the rim (if it’s reusable) so make sure you put your flat tire in the same place your spare was.

Go to a Garage

Don’t procrastinate and get your car into a garage. You’ll need to put a regular-sized tire on as soon as possible.

You Might Also Like